5 Series E39 540i (M62) SAL
Fit sprocket with chain to inlet camshaft on cylinder bank 1 to 4
with long bores aligned centrally.
Brace sprocket, press bow cover against the timing chain and
check the position of the long bores.
If necessary, remove sprocket once again and align position of
long bores centrally.
Fit sensor gear with mark on sensor gear in cylinder shaft pointing
upwards.
Insert screws and fit flush.
Attach special tool 11 7 380 to right cylinder head (cylinder
bank 1 to 4).
Install special tool 11 3 390 in special tool 11 7 380.
Tighten bow cover by turning the adjusting screw on the special
tool 11 3 390 with special tool 00 9 250 to 0.7 Nm.
Note:
If installation tolerance is unfavorable, attach special
tool 00 9 250 from underside.
RA Removing and installing right cylinder head (M62 up to 9/98)
BMW AG - TIS
20.02.2013 11:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
