6 Series 645Ci (N62) Coupe
Important!
A second person is required to help in removing and installing
the glass tilt sunroof lid!
Raise sunroof lid at rear (1) uniformly until access from side (2)
is possible.
Lift out sunroof lid.
Installation:
Tape off installation area on left and right at roof aperture with
fabric adhesive tape.
Insert sunroof lid carefully and uniformly.
Tighten Torx screws only to such an extent that sunroof lid can still
just be adjusted.
Close slide/tilt sunroof lid, check for correct alignment and adjust if
necessary.
Tighten down Torx screws.
Tightening torque 54 10 5AZ
.
RA Removing and installing glass tilt sunroof lid
BMW AG - TIS
18.01.2013 10:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
