7 Series E38 740d (M67) SAL
Disconnect EGR pipe on left (2).
Loosen screws (1).
Installation:
- Clean sealing faces (1) on left and right.
- Replace seals on EGR pipes.
Loosen screws (1).
Installation:
Observe standard tightening torque of M7 screws.
Raise water pipe (1) a little.
Withdraw water pipe (1) from thermostat housing (2).
RA Removing and installing/sealing or replacing oil-water heat exchanger (M67)
BMW AG - TIS
10.02.2013 02:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
