X Series E70 X5 4.8i (N62TU) OFFRD
Unlock plug on pulse generator of left and right inlet camshafts and disconnect
Unlock plug on pulse generator of left and right exhaust camshafts and disconnect
Unlock plugs on both solenoid valves on left side and disconnect
Unlock plugs on both solenoid valves on right side and disconnect
Unlock plugs on left and right Valvetronic servomotors and disconnect
Unlock plugs on left and right eccentric shaft sensors and disconnect
Unlock plug on throttle valve potentiometer and disconnect
Unlock plug on differential pressure sensor and disconnect
Unlock plug on DISA servomotor and disconnect
Release negative lead on spring strut dome
Tightening torque 12 42 7AZ
.
Unlock plug connections in electronics box and disconnect:
•
at DME control unit
•
at Valvetronic control unit
•
at supply module
•
Do not remove control
units
Disconnect vent line
Release cable duct from intake manifold and remove wiring harness
Installation:
Now clear the fault memory.
RA Replacing wiring harness section for engine (N62TU)
BMW AG - TIS
08.02.2013 00:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
