X Series E70 X5 4.8i (N62TU) OFFRD
12 51 100
Replacing wiring harness section for ignition
coil (N62TU)
Necessary preliminary tasks:
•
Switch off ignition
•
Read out fault memory of DME control unit; if necessary,
work through test schedules
•
Disconnect battery negative lead
•
Remove microfilter housing
•
Remove intake hose
•
Remove intake filter housing
Release screws and remove holder (1).
Pull ignition coil covers (2) out of rubber grommets.
Release screws and remove grounding cable.
Tightening torque 12 42 8AZ
.
Observe routing of suppression line.
Work step
Note:
Unlock plug connections on DME control unit and disconnect
•
Only plug connections of wiring
harness section for ignition coils
•
Do not remove control unit.
Unlock plug connections on ignition coils and disconnect
Do not remove ignition coils
This work step is described in the
section "Replacing ignition coil".
Remove engine vent hose
Unclip and remove wiring harness.
RA Replacing wiring harness section for ignition coil (N62TU)
BMW AG - TIS
08.02.2013 00:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
