X Series E70 X5 4.8i (N62TU) OFFRD
Important!
Do not release tension strut from swivel bearing with impact
tool.
Make sure special tool rests correctly on steel bushing of
swivel bearing. The swivel bearing must be removed if the
steel bushing moves.
Rubber gaiter of tension strut must not be damaged!
Do not pull stainless steel ring off journal.
Slacken nut (1) two to three thread turns.
If necessary, replace lower section 31 2 242 with lower
section 31 2 247 .
Press tension strut (2) with special tool 31 2 240 off swivel
bearing.
Unscrew nut (1) and remove tension strut (2) from swivel
bearing.
Installation:
Keep tension strut to swivel bearing connection clean and free
from oil and grease.
Replace self-locking nut.
Tightening torque 31 12 2AZ
.
RA Removing and installing/replacing left or right tension strut
BMW AG - TIS
08.02.2013 02:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
