Riviera V6-3.8L SC VIN 1 (1995)
Crankshaft Main Bearing Seal: Service and Repair
REAR MAIN SEAL
Tool Required: J 38196 Rear Main Seal Installer
Remove or Disconnect
1. Flywheel.
2. Confirm rear seal leak.
3. Insert a screwdriver or similar tool in through the dust lip at an angle as shown in Figure. Pry seal out by moving the handle of the tool towards the
end of the crankshaft pilot. Repeat as required around the seal until seal is removed.
Important
^
Care must be taken not to damage crankshaft OD surface or chamfer with pry tool.
Inspect
^
Check ID of bore for nicks or burrs and correct as required. Inspect crankshaft for burrs or nicks on surface which contacts seal. Repair or replace
crankshaft as required.
Install or Connect