Riviera V6-3.8L SC VIN 1 (1995)
1. Apply engine oil to ID and OD of new seal. Slide new seal over mandrel until back of seal bottoms squarely against collar of tool.
2. Seal.
a. Attach tool to crankshaft by hand, or tighten attaching screws to 5 Nm (60 lb. in.).
b. Turn T-handle of tool so that collar pushes seal into the bore, turn the handle until the collar is tight against the case. This will ensure the seal
is seated properly.
c. Loosen the T-handle of the tool until it comes to a stop. This will ensure that the collar will be in the proper position for installing another new
seal.
d. Remove attaching screws.
3. Flywheel.
Tighten
^
Flywheel bolts to 15 Nm + 50° (11 lb. ft. + 50°).
Inspect
^
Proper fluid levels.
^
Leaks.
^
Completion of repair.
