Skylark V6-3100 3.1L VIN M SFI (1996)
^
Install transfer tube assemblies in ports in hydraulic modulator and push in by hand to bottom.
2. Lubricate new banjo bolt 0-ring with clean brake fluid and install into the master cylinder and hydraulic modulator.
3. Hydraulic modulator to master cylinder.
^
Clamp mounting flange of master cylinder in a vise.
^
Hold hydraulic modulator and rock into position on master cylinder, inserting transfer tube assemblies into master cylinder ports.
4. Two modulator to master cylinder banjo bolts.
TIGHTEN
^
Banjo bolts to 24 Nm (18 lb. ft.).
Gear Positioning
5. With the hydraulic modulator upside down, and the gears facing you, rotate each hydraulic modulator gear counterclockwise until movement
stops. This procedure will position the pistons very close to the top of the hydraulic modulator bore.
6. Motor pack to hydraulic modulator/master cylinder assembly.
7. Four Torx head screws.
TIGHTEN
^
Torx head screws to 5 Nm (44 lb. in.).
8. Gear cover to hydraulic modulator/master cylinder assembly.
TIGHTEN
^
Torx bolts to 4 Nm (36 lb. in.).
