Skylark V6-3100 3.1L VIN M SFI (1996)
Left Side Of Engine Compartment
8. Remove the accelerator cable from vehicle noting cable routing.
INSTALL OR CONNECT
CAUTION: In order to prevent possible interference and damage, flexible components (hoses, wires, conduits, etc.) must not be routed within 50
mm (2 in.) of moving pans, unless the routing is positively controlled.
1. Install accelerator cable into car using routing noted during removal -
2. Install the snap retainer through the bulkhead.
3. Install the accelerator cable through the slot in the accelerator pedal lever.
4. Seat the snap retainer in the accelerator pedal lever.
5. Install the accelerator cable to the throttle body lever.
6. Install the accelerator cable to the accelerator cable bracket.
7. Install the accelerator cable into the retaining clip.
8. Install the left instrument panel sound insulator.
9. Install the accelerator cable shield, it equipped.
10. Inspect and check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the
accelerator pedal.
11. Inspect the throttle should operate freely, without binding, between full closed and wide open throttle.
