Allante V8-273 4.5L (1991)
1.
Install the accelerator pedal, pedal retainer, and spring.
2.
Connect the accelerator on the accelerator pedal.
3.
Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for proper carpet fit under the
accelerator pedal.
4.
The throttle should operate freely without binding between full closed and wide open throttle.
THROTTLE CONTROL CABLE
REMOVAL:
1.
Disconnect the accelerator cable from the accelerator pedal.
2.
Remove the accelerator cable retainer.
3.
Squeeze the accelerator cable cover tangs and push the cable through the dash panel.
4.
Remove the accelerator cable retaining clip and the accelerator cable.
5.
Squeeze the accelerator cable cover tangs and push the cable through the accelerator cable bracket.
INSTALLATION:
CAUTION: To prevent possible interference, flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2") of moving parts
unless routing is positively controlled.
1.
Reverse the removal procedure.
2.
Check for complete throttle opening and closing positions by operating the accelerator pedal. The throttle should operate freely without bind
between full closed and wide open throttle.
