CTS V6-2.8L (2006)
Steering Shaft: Service and Repair
Intermediate Steering Shaft Replacement - Center
Intermediate Steering Shaft Replacement - Center
Tools Required
^
J42640 Steering Column Anti-Rotation Pin
Removal Procedure
1. Notice: The front wheels of the vehicle must be maintained in the straight ahead position and the steering column must be in the LOCK position
before disconnecting the steering column or intermediate shaft. Failure to follow these procedures will cause improper alignment of some
components during installation and result in damage to the SIR coil assembly.
Turn the steering wheel so that the front wheels are pointing straight ahead.
2. Turn the ignition lock cylinder to the LOCK position and remove the key.
3. Install the J42640 through the access hole in the lower steering column trim cover in order to lock the steering column.
4. Raise and support the vehicle. Refer to Vehicle Lifting.
5. Remove the upper intermediate steering shaft to center intermediate steering shaft bolt.
