CTS V6-3.2L VIN N (2003)
CAUTION: Sectioning should be performed only in the recommended areas. Failure to do so may compromise the structural integrity of
the vehicle and cause personal injury if the vehicle is in a collision.
IMPORTANT: This panel is replaced at factory seams.
3. Remove all related panels and components.
4. Restore as much of the damage as possible.
5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Service
Precautions.
IMPORTANT: : Note the number and location of the factory welds for installation of the rear end panel.
6. Locate, mark, and drill out all the necessary factory welds.
7. Remove the rear end panel.
INSTALLATION PROCEDURE
IMPORTANT: : In any area damaged beyond recognition, space the plug weld holes every 40 mm (1-1/2 in.) apart.
