CTS V8-5.7L VIN P (2004)
9. Carefully pull the harness from inside the vehicle up through and in behind the shoulder belt retractor.
10. Remove the electrical harness from the vehicle.
INSTALLATION PROCEDURE
1. Position the single end connector first in behind the shoulder belt retractor down into the rear compartment.
2. Connect the electrical connector (1) to the main body electrical harness (2).
3. Install the rear compartment side trim panel.
4. Secure the electrical harness clips to the rear drain hose.
5. Connect the electrical connectors (1,3) to the sunroof motor.
6. Secure the harness to the sunroof motor with new electrical tape (5).
7. Connect the electrical connectors to the sunroof control unit.
8. Install the control unit to the sunroof module.
9. Ensure the locking tabs are secure.
10. Secure the electrical harness to the drive cable tube with 2 new tie straps.