CTS V8-5.7L VIN P (2004)
4. Notice: Refer to Fastener Notice in Service Precautions.
Important: Use New EBCM/BPMV screws after separating the EBCM from the BPMV.
Install the 4 NEW EBCM to BPMV screws.
Tighten the (4) NEW EBCM to BPMV screws in sequence (1-4) to 5 Nm (44 inch lbs.).
5. Install the EBCM/BPMV assembly to the BPMV bracket.
6. Install the 6 BPMV mounting bolts.
Tighten the BPMV nuts to 10 Nm (89 inch lbs.).
7. Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
Connect the EBCM electrical connector (1) to the EBCM (3).
8. Rotate the EBCM connector tab (2) to the locked position.
9. Install the front air deflector.
10. Lower the vehicle.
11. Caution: The brake pipes must be fully installed to the brake pipe mounting retainers on the frame. Failure to properly retain the brake pipes may