CTS V8-5.7L VIN P (2004)
cause the pipes to contact the frame and/or the transmission resulting in possible loss of brake fluid and personal injury.
Caution: Make sure brake pipes are correctly connected to BPMV. If brake pipes are switched by mistake Inlet vs. Outlet, wheel lockup will
occur and personal injury may result.
Important: If a new BPMV is being installed, remove the shipping plugs from the valve openings.
Install the 3 wheel brake pipes (2) to the BPMV (1) using the locations recorded during the removal procedure.
Tighten the back 3 wheel brake pipes to 27 Nm (20 ft. lbs.).
12. Carefully lift the right side of the radiator up and move rearward to access the front brake pipe of (BPMV).
13. Carefully install the front brake pipe from the (BPMV).
Tighten the wheel brake pipe to 27 Nm (20 ft. lbs.).
14. Install the 2 master cylinder brake pipes (3) to the BPMV (1) using the locations recorded during the removal procedure.
Tighten the master cylinder brake pipes to 27 Nm (20 ft. lbs.).
15. Carefully connect the brake pressure switch electrical connector.
16. Carefully move the right side of the radiator rearward into the insulator in the frame.
17. Install the upper radiator support bracket.
18. If equipped with a brake fluid pressure sensor (4), connect the electrical connector.
19. Install the right front wheel house liner.
20. Install the air deflector.
21. Install the right front tire and wheel assembly.
22. Fill and bleed the hydraulic brake system.
23. Perform the Auto Bleed Procedure.
24. Perform the ABS Diagnostic System Check.