CTS V8-5.7L VIN P (2004)
1. Notice: Refer to Fastener Notice in Service Precautions.
If necessary, install the exhaust manifold heat shield and bolts.
Tighten the exhaust manifold heat shield bolts to 9 Nm (80 inch lbs.).
2. Position the exhaust manifold and a NEW gasket into place.
3. Lower the vehicle.
4. Install the exhaust manifold bolts.
5. Raise and suitably support the vehicle.
6. Connect the center steering shaft to the lower steering shaft.
7. Install the left catalytic converter.
8. Lower the vehicle.
9. Install the left bank spark plugs.
10. Install the left bank coil assembly.
11. Install the fuel injector sight shield.