CTS V8-5.7L VIN P (2004)
16. Connect the inflator module to the adapter (2) on the SIR deployment harness (1).
17. Place a 12 V minimum/2 A minimum power source (i.e., vehicle battery) near the shorted end of the harness.
IMPORTANT:
-
The rapid expansion of gas involved with deploying an inflator module is very loud. Notify all the people in the immediate area that you intend to
deploy the inflator module.
-
When the inflator module deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal reaction of the inflator module
due to the force of the rapid expansion of gas inside the inflator module.
-
If you are deploying a dual stage inflator module with stage 1 already deployed, the fixture may not move and the noise may have been reduced.
1. Clear the area of people.
2. Separate the 2 banana plugs on the SIR deployment harness.
3. Connect the SIR deployment harness wires to the power source. Inflator module deployment will occur when contact is made.