CTS Sedan AWD V6-3.0L (2010)
2. Using the J-41013 - Rotor Resurfacing Kit , thoroughly clean any rust or corrosion from the mating surface and mounting surface of the brake
rotor.
3. Inspect the mating surfaces of the hub/axle flange and the rotor to ensure that there are no foreign particles or debris remaining.
4. Install the brake rotor to the hub/axle flange. Use the matchmark made prior to removal for proper orientation to the flange.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. Install the brake rotor screw (1) and tighten to 12 Nm (106 lb in).
Note: If reusing the caliper bracket bolts the threads of the caliper bracket bolts and the threads of the knuckle mounting holes must be free of
residue and debris prior to application of threadlocker in order to ensure proper adhesion and fastener retention.
6. Prepare the bolts and the threaded holes for assembly:
*
Thoroughly clean the residue from the bolt threads by using denatured alcohol or equivalent and allow to dry.
*
Thoroughly clean the residue from the threaded holes by using denatured alcohol or equivalent and allow to dry.
*
Apply threadlocker GM P/N 12345493 (Canada P/N 10953488), or equivalent to 2/3 of the threaded length of the lower caliper bracket bolts.
Ensure there are no gaps in the threadlocker along the length of the filled area of the bolts.
*
Allow the threadlocker to cure approximately 10 minutes before installation.
