CTS Sedan AWD V6-3.0L (2010)
4. Inspect the O-ring seals on the spindle and the cable for damage and correct positioning and replace, if necessary.
5. Install the park brake cable fitting to the spindle.
Ensure the park brake cable fitting is engaged in the actuator in the spindle.
6. Position the park brake cable collar to the spindle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: When installing the electronic park brake cable nut to the electronic park brake module spindle, hold the spindle housing securely to avoid
distorting the housing.
7. Install the park brake cable nut (1) to the electronic park brake module spindle by rotating the nut clockwise and tighten to 6 Nm (53 lb in).
8. Install the exhaust system. Refer to Exhaust System Insulator, Hanger, Bracket Replacement (See: Engine, Cooling and Exhaust/Exhaust
System/Exhaust Pipe/Muffler Hanger/Service and Repair/Exhaust System Insulator, Hanger, Bracket Replacement).
9. Lower the vehicle.
10. Set the electric park brake cable tension. Refer to Parking Brake Cable Adjuster Enabling (Electric Park Brake) (See: Procedures/Parking Brake
Cable Adjuster Enabling (Electric Park Brake)).
