cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Console Armrest Replacement - Front Floor (DTS)|Page 13816 > < Console Armrest Replacement - Front Floor (DTS)|Page 13814
Page 2
background image

1. Install the center console to the vehicle.
2. Connect the center console electrical connectors.
3. Align the locating pins on the center console to the IP.

Notice:  Refer to Fastener Notice  in Cautions and Notices.

4. Install the 2 upper console to IP fasteners (1).

Tighten the fasteners (1) to 9 N.m (80 lb in).

5. Install the 2 lower console to IP fasteners (2).

Tighten the fasteners (2) to 9 N.m (80 lb in).

6. Adjust the front seats to the forward position.
7. Install the 2 rear console to floor fasteners (4).

Tighten the fasteners (4) to 9 N.m (80 lb in).

8. Adjust the front seats to the rear position.
9. Install the 2 front console to floor fasteners (3).

Tighten the fasteners (3) to 9 N.m (80 lb in).

10. Install the IP center compartment. Refer to Instrument Panel Compartment Replacement (Base and DHS)  (See: Glove Compartment/Service and

Repair/Instrument Panel Compartment Replacement (Base and DHS))Instrument Panel Compartment Replacement (DTS)  (See: Glove
Compartment/Service and Repair/Instrument Panel Compartment Replacement (DTS)) 

11. Slide the transaxle range selector cable fully into the console until it snaps into place.
12. Connect the transaxle range selector cable terminal to the shift lever pin.
13. Install the console center trim plate. Refer to Front Floor Console Trim Plate Replacement (DTS)  (See: Front Floor Console Trim Plate

Replacement) .

14. Install the right knee bolster. Refer to Passenger Knee Bolster Replacement  (See: Dashboard / Instrument Panel/Service and Repair/Passenger

Knee Bolster Replacement) .

15. Install the left knee bolster. Refer to Driver Knee Bolster Replacement (Without UV2)  (See: Dashboard / Instrument Panel/Service and

Repair/Driver Knee Bolster Replacement (Without UV2))Driver Knee Bolster Replacement (UV2)  (See: Dashboard / Instrument Panel/Service
and Repair/Driver Knee Bolster Replacement (UV2)) .

16. Install both the left and the right console trim panels. Refer to Front Floor Console Side Trim Panel Replacement - Left Side (DTS)  (See: Front

Floor Console Side Trim Panel Replacement - Left Side (DTS)) and Front Floor Console Side Trim Panel Replacement - Right Side (DTS)  (See:
Front Floor Console Side Trim Panel Replacement - Right Side (DTS)) .

17. Enable the SIR system. Refer to Enabling the SIR System.

Console Armrest Replacement - Front Floor (DTS)|Page 13816 > < Console Armrest Replacement - Front Floor (DTS)|Page 13814