Fleetwood V8-368 6.0L VIN 9 FI (1982)
Suspension Spring ( Coil / Leaf ): Service and Repair
Front Coil Spring
Fig. 5 Removing and installing front spring. Brougham & DeVille
1.
Raise vehicle on hoist, remove shock absorber lower mounting bolts and push shock through control arm up into spring.
2.
Support vehicle so control arms hang free and disconnect stabilizer bar from lower control arm.
3.
Secure tool No. J-23028-01 to a suitable jack, position tool so lower control arm is supported by inner bushings, Fig. 5.
4.
Raise jack to relieve spring tension from lower control arm pivot and install a safety chain around spring and through lower control arm.
5.
Remove bolt from rear of lower control arm, then remove other bolt and slowly lower control arm until all spring tension is relieved.
6.
Remove safety chain, spring and spring insulator.
7.
Reverse procedure to install. When installing spring, bottom coil must cover all or part of one inspection hole on the lower control arm. The
other inspection hole must be fully or partially uncovered.
