Fleetwood V8-368 6.0L VIN 9 FI (1982)
E.
Repeat step D until car has been run with clamp heads located at all four marks on the shaft.
FIGURE 8 - ROTATING CLAMPS ON PROPELLER SHAFT
F.
Position clamps at point of minimum unbalance. Rotate the clamp heads away from each other 45~, one each way from the point of minimum
unbalance, refer to Figure 8. Run the car and note if unbalance has improved.
G.
Continue to rotate the clamps apart in smaller angular increments until the feel for unbalance is best.
FIGURE 9 - INSTALLING VIBRATION DAMPENER
IX. On vehicles without factory-installed dampener, install vibration dampener, P/N 1628581, on the left rear axle tube and torque to 40 N-m (30 ft.lbs.),
refer to Figure 9.
A.
If there is an interference condition between the dampener and the stabilizer bar it may be necessary to install a piece of rubber hose over the
stabilizer bar, refer to Figure 9.
NOTE:
DO NOT CLAMP THE "U" BOLT OVER THE REAR BRAKE PIPE.
