SRX AWD V6-3.0L (2010)
Note: Lift the dash panel insulator slightly to install the upper master cylinder heat shield nut.
15. Install the master cylinder heat shield nuts (1) and tighten to 25 Nm (18 lb ft).
16. Install the radiator surge tank. Refer to Radiator Surge Tank Replacement (LF1) (See: Engine, Cooling and Exhaust/Cooling System/Coolant
Reservoir/Service and Repair/Radiator Surge Tank Replacement)Radiator Surge Tank Replacement (LAU) (See: Engine, Cooling and
Exhaust/Cooling System/Coolant Reservoir/Service and Repair/Radiator Surge Tank Replacement).
17. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic
Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair).
18. Turn the ignition switch to the ON position.
19. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle).
20. Observe the brake pedal feel after performing the diagnostic system check. If the pedal now feels spongy, air may have been in, or may have been
introduced into the primary circuit.
21. If the pedal feels spongy, perform the Antilock Brake System Automated Bleed (See: Brake Bleeding/Service and Repair).