SRX AWD V6-3.0L (2010)
3. Install the intake manifold assembly (2).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the intake manifold bolts (1).
Intake Tightening Sequence (LF1 or LFW)
5. Tighten the intake manifold bolts in the sequence shown.
6. Tighten the intake manifold bolts in sequence to 23 Nm (17 lb ft).
7. Tighten the intake manifold bolts a second pass in sequence to 23 Nm (17 lb ft).
8. Remove the fuel pipe shield. Refer to Fuel Pipe Shield Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Supply
Line/Service and Repair/Fuel Pipe Shield Replacement).
