SRX AWD V6-3.0L (2010)
Caution: Do not cut through the wheel drive shaft inboard or outboard boot during service. Cutting through the boot may damage the sealing
surface of the housing and the tripot or the constant velocity joint bushing. Damage to the sealing surface may lead to water and dirt intrusion and
premature wear of the constant velocity joint.
Note: The following procedure is for the wheel drive shaft that has the low profile boot clamp. If the wheel drive shaft is equipped with the ear
type boot clamp, proceed to step 6.
3. Using the appropriate tool, remove and discard the outer boot clamp (2) from the CV joint boot (3).
4. Using a pair of side cutters, remove and discard the inner boot clamp (4) from the CV joint boot (3).
5. Remove the CV joint boot (3) from the CV joint housing (1).
6. Using a pair of side cutters, remove and discard the outer boot clamp (3) and the inner boot clamp (1).
7. Remove the CV joint boot (2) from the CV joint housing (4).
