cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Removal and Replacement|Page 13697 > < Removal and Replacement|Page 13695
Page 3
background image

*

Thoroughly clean the residue from the threaded holes by using denatured alcohol or equivalent and allow to dry.

4. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488), or equivalent to 2/3 of the threaded length of the lower caliper bracket bolts.

Ensure that there are no gaps in the threadlocker along the length of the filled area of the bolts.

5. Allow the threadlocker to cure approximately 10 minutes before installation.
6. Apply a thin coat of high temperature silicone brake lubricant to the brake caliper pin bolts.

Notice:  Refer to Fastener Notice  (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .

7. Install the brake caliper pin bolts.

Tighten the brake caliper pin bolts to 34 N.m (25 lb ft).

8. Remove the plug from the brake caliper opening and the brake hose.

Important:  Install NEW copper brake hose gaskets.

9. Assemble the NEW copper brake hose gaskets, and the brake caliper bolt to the brake hose.

10. Install the brake hose and the brake caliper bolt to the brake caliper.

Tighten the brake hose to caliper bolt to 50 N.m (37 lb ft).

11. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure)  (See: Brake Bleeding/Service and Repair)Hydraulic

Brake System Bleeding (Manual)  (See: Brake Bleeding/Service and Repair) .

12. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then repeat steps 11 and 12 until a firm brake pedal apply is obtained. This will properly seat the brake caliper pistons and brake

pads.

15. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation  (See: Maintenance/Wheels and Tires/Service and Repair) .
16. Lower the vehicle.

Front Brake Caliper Bracket Replacement

Front Brake Caliper Bracket Replacement
Caution:
  Refer to Brake Dust Caution  (See: Service Precautions/Technician Safety Information/Brake Dust Caution) .

Removal Procedure

Caution:  Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in personal
injury.

Removal and Replacement|Page 13697 > < Removal and Replacement|Page 13695