SRX AWD V6-3.6L (2008)
Assembly Procedure
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
1. Install the valve stem seal (2) over the threaded end of the bleeder valve (1).
2. Install the brake caliper bleeder valve (1).
Tighten the brake caliper bleeder valve to 14 N.m (124 lb in).
3. Install the brake caliper bleeder valve cap.
4. Lubricate the new piston seals (1) with Delco Supreme 11(R), GM P/N 12377967 (Canadian P/N 992667) or equivalent DOT-3 brake fluid from a
clean, sealed brake fluid container.
5. Install lubricated piston seals (1) into the brake caliper bore seal grooves.
6. Make sure the seals are not twisted.
