SRX AWD V6-3.6L (2008)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Install the 4 screws connecting the EBCM to the BPMV.
Tighten the screws in sequence (1-4) to 5 N.m (44 lb in).
Important: Verify that the rubber isolator is installed on the BPMV. The isolator protects the EBCM/BPMV assembly from vehicle
vibrations.
5. Install the EBCM/BPMV assembly (1) to the BPMV bracket.
6. Install the BPMV bracket nuts (2).
Tighten the nuts to 10 N.m (89 lb in).
Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
