SRX AWD V6-3.6L (2008)
10. Disconnect the intermediate cable (2) from the rear equalizer (3).
11. Disconnect the intermediate cable (2) from the right rear park brake cable connector (1).
12. Disconnect the intermediate cable housing from the rear cable housing retaining bracket by depressing the locking retainer.
13. Remove the intermediate cable from the vehicle.
Installation Procedure
1. Route and install the intermediate park brake cable into park brake cable retaining bracket.
2. Properly seat the intermediate park cable into the park brake cable retaining bracket.
3. Connect the right rear parking brake cable connector (1) to the intermediate park brake cable (2).
4. Connect the intermediate park brake cable (2) to the equalizer (3).
5. Install the park cable guides (2).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
6. Install the park brake cable guide bolt (1) to the floor pan.
Tighten the bolt to 10 N.m (89 lb in).
7. Install the park brake cable guide nut (3) to the mounting stud.
Tighten the nut to 10 N.m (89 lb in).
