SRX AWD V6-3.6L (2008)
11. Disconnect the electrical connector from the park brake warning lamp switch.
12. Remove the park brake warning lamp switch wiring harness retainer from the park brake pedal assembly and position the harness out of the way.
13. Remove the park brake pedal assembly nuts (1).
14. Remove the park brake pedal and cable assembly (2) from the vehicle.
Installation Procedure
1. Install the park brake pedal and front park brake cable assembly (2) to the instrument panel carrier.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the park brake pedal assembly nuts (1).
Tighten the nuts to 25 N.m (18 lb ft).
