SRX AWD V6-3.6L (2008)
When power is supplied there is a 5 second delay until the pump works. The pump has it own vacuum sensor that turns the pump on and off. If the
vacuum level drops below 6 inches of mercury the pump will turn on. Once it reaches 9 inches of mercury it will turn off. The pump can be check
by removing the hose at the booster. Place you thumb over the hose and feel the vacuum pull down until it stops, release the vacuum and it should
start again. If the pump runs continuous for 1 minute it will shut down until next key cycle to prevent overheating.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer