cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Valve Stem Oil Seal and Valve Spring Replacement - Left Side|Page 4050 > < Camshaft Cover Replacement - Left Side|Page 4045
Page 1
background image

Valve Spring: Service and Repair
Valve Stem Oil Seal and Valve Spring Replacement - Left Side

Valve Stem Oil Seal and Valve Spring Replacement - Left Side

Tools Required

*

EN 46106 Flywheel Holding Tool

*

EN 46110 On-Vehicle Valve Spring Compressor

*

EN 46116 Valve Stem Seal Remover/Installer

*

EN 46117 Valve Stem Key Remover/Installer

*

J 39313 Spark Plug Port Adapter

Removal Procedure

1. Remove the starter motor. Refer to Starter Motor Replacement (LY7 - Gas, 6 Cylinder, 3.6L, SFI, V6)  (See: Starting and Charging/Starting

System/Starter Motor/Service and Repair)Starter Motor Replacement (LH2 - Gas, 8 Cylinder, 4.6L, SFI, V8, DOHC, HO)  (See: Starting and
Charging/Starting System/Starter Motor/Service and Repair) .

Important:  If the EN 46106  is not installed, the crankshaft may rotate. If the crankshaft rotates, disassembly and reassembly of the
entire camshaft timing system may be required.

2. Install the EN 46106  in order to prevent crankshaft rotation.
3. Remove the camshafts and rocker arms. Refer to Camshaft Replacement - Left Side  (See: Camshaft, Lifters and Push Rods/Camshaft/Service and

Repair/Camshaft Replacement - Left Side) .

4. Remove the spark plug from the applicable cylinder. Refer to Spark Plug Replacement  (See: Tune-up and Engine Performance Checks/Spark

Plug/Service and Repair) .

5. Install the J 39313  to the applicable cylinder.
6. Connect the J 39313  to a compressed air source.

Valve Stem Oil Seal and Valve Spring Replacement - Left Side|Page 4050 > < Camshaft Cover Replacement - Left Side|Page 4045