SRX AWD V6-3.6L (2008)
3. Connect the inside air temperature sensor electrical connector (1).
Important: Assure that the foam seal tape is in place and covering the openings on the sides of the grille assembly (2).
4. Install the inside air temperature sensor (2) into the I/P.
5. Connect the aspirator hose to the HVAC module.
6. Install the knee bolster. Refer to Knee Bolster Replacement (Left Hand Drive) (See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair)Knee Bolster Replacement (Right Hand Drive) (See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair) .
