SRX AWD V6-3.6L (2008)
Notice: Refer to Fastener Notice .
2. Install the HVAC control module screws (1).
Tighten the screws to 2 N.m (18 lb in).
3. Connect the HVAC control module electrical connector.
4. Connect the ash tray electrical connector.
5. Install the HVAC control module trim plate by pressing trim until tabs engage.
6. Install the screw behind the ashtray.
Tighten the screw to 2 N.m (18 lb in).
7. Place the transmission in park and unapply the parking brake.
8. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for programming and setup information.
Blower Motor Control Processor Replacement (Left Hand Drive)
Blower Motor Control Processor Replacement (Left Hand Drive)
