SRX AWD V6-3.6L (2008)
10. Remove the condenser tube bolt.
11. Disconnect the condenser tube from the condenser.
12. Remove and discard the O-ring.
13. Disconnect the high pressure sensor electrical connector.
14. Remove the condenser tube.
15. Remove the high pressure sensor.
Installation Procedure
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
1. Install the high pressure sensor.
Tighten the sensor to 9.8 N.m (87 lb in).
2. Install the condenser tube.
3. Connect the high pressure sensor electrical connector.
4. Install a new O-ring to the condenser tube. Refer to O-Ring Replacement (See: Coupler HVAC/A/C Coupler O-ring/Service and Repair) .
5. Connect the condenser tube to the condenser.
6. Install the condenser tube bolt.
Tighten the sensor to 9 N.m (80 lb in).
7. Install the front air deflector.
8. Install the front air deflector retainers.
