SRX AWD V6-3.6L (2008)
See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Specifications/Capacity Specifications/6L50/6L80/6L90 - Automatic
Transmission) . To avoid an under-fill condition, slightly overfill the transmission, and then allow the extra fluid to drain during the fluid checking
procedure.
Important: The J 45096 is being utilized as a convenient method to pump the fluid into the bottom pan. A suitable hand pump may also
be used instead. When using the J 45096 , monitor the display panel to determine the amount of fluid being pumped from the tool supply
tank into the transmission.
4. Using the DT 47784 (1), J 45096-30 (2), and the J 45096 (3), add transmission fluid through the check plug hole. Refer to Transmission Fluid
Cooler Flushing and Flow Test (J 45096) (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and
Inspection/Component Tests and General Diagnostics/6L50/6L80/6L90 - Automatic Transmission/Transmission Fluid Cooler Flushing and Flow
Test (J 45096)) for complete J 45096 operating instructions. Use the FLOW position on the main function switch to pump the fluid.
Important: Failure to start the engine and move the shift lever through the gear ranges before removing the DT 47784 and J 45096-30
from the bottom pan will result in an excess amount of fluid draining from the check plug hole. This may lead to an under-fill condition.
5. Start the engine and move the shift lever through each gear range. Pause for at least 3 seconds in each gear range.
6. With the engine still running, remove the DT 47784 (1), J 45096-30 (2), and J 45096 (3) and then check the fluid level. Refer to Transmission
Fluid Check (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General
Diagnostics/6L50/6L80/6L90 - Automatic Transmission/Transmission Fluid Check) .
Transmission Fluid, Fluid Pan and/or Filter Replacement
Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement
