SRX AWD V6-3.6L (2008)
Pressure Regulating Solenoid: Service and Repair
Pressure Control Solenoid Valve Replacement
Removal Procedure
1. Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement (See: Service and Repair/Removal
and Replacement) .
2. Disconnect the electrical wiring harness connector (2) from the pressure control solenoid (1).
3. Using a small screwdriver or pick, remove the pressure control solenoid retainer from the control valve body.
4. Remove the pressure control solenoid (1) from the control valve body.
5. Remove the O-ring seals (3-4) from the pressure control solenoid (1), ONLY if the O-rings are cut or worn.
Installation Procedure