SRX RWD V8-4.6L VIN A (2006)
3. Install the lower control arm to knuckle bolt.
4. Install the rear coil spring.
5. Notice: Refer to Fastener Notice in Service Precautions.
Tighten the following fasteners:
^
Tighten the lower control arm to frame bolt to 135 Nm (100 ft. lbs.).
^
Tighten the lower control arm to frame nut to 135 Nm (100 ft. lbs.).
^
Tighten the lower control arm to knuckle bolt to 160 Nm (118 ft. lbs.).
6. Connect the stabilizer shaft link to the lower control arm.
7. Install the stabilizer shaft link lower retaining nut.
8. Install the tire and wheel.
9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.