STS RWD V8-4.6L (2007)
Installation Procedure
1. Install new engine oil cooler hose/pipe seals.
Notice: Refer to Fastener Notice.
2. Install the external engine oil cooler quick connect fitting.
Tighten the fitting to 18 N.m (13 lb ft).
Important: The quick connect fitting must be pushed on and then pulled back to verify proper connector engagement.
3. Install the engine oil cooler hose/pipes to the external oil cooler.
4. Remove the oil drain pan from under the vehicle.
5. Install the left lower front bumper close out panel.
6. Refill the engine with oil and check for leaks.