STS RWD V8-4.6L (2007)
and later have an 11 x 1.5 mm flywheel/flexplate crankshaft bolt hole thread.
16. Ensure the proper size of bolt (2) 8 mm or (3) 11 mm is being installed in the J 45930-A.
17. Turn the center nut (1) of the J 45930-A until the center hub (2) protrudes approximately 15 mm (0.591 in) beyond the outer plate (3).
Important: DO NOT use any lubricant in order to install the crankshaft rear oil seal. Do not use any lubricant on the coating pre-applied
to the inner diameter of the crankshaft rear oil seal. The coating is a sealant that must not be contaminated. Do not use any lubricant on
the outer diameter of the crankshaft rear oil seal. The sealant applied to the bore of the engine block will not properly bond to a
lubricated crankshaft rear oil seal.
18. Do not lubricate any part of the new cassette style crankshaft rear oil seal.