XLR V8-4.6L VIN A (2006)
Body Emblem: Service and Repair
Emblem/Nameplate Replacement - Front Fender
Emblem/Nameplate Replacement - Front Fender
Tools Required
J 25070 Heat Gun
Removal Procedure
1. When replacing an emblem/nameplate, do the following:
1. Use tape to protect the mounting surface during removal.
2. Use tape for alignment marks for installation of the emblem/nameplate.
2. To remove an emblem/nameplate, heat the emblem/nameplate using a J 25070 .
3. Apply the heat using a circular motion for about 30 seconds holding the J 25070 approximately 152 mm (6 in) from the surface.
Notice: Refer to Exterior Trim Emblem Removal Notice in Service Precautions.
4. Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.
Installation Procedure
Important: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the
sticky backing. Foreign material may cause improper adhesion.
1. Clean the area where the emblem/nameplate will be installed.
Use a lint free cloth and Varnish Makers and Painters (VMP) naphtha, or a 50/50 mixture, by volume of isopropyl alcohol and water to clean the
area.
2. Dry the area thoroughly.
3. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions: