XLR V8-4.6L VIN A (2006)
4. For the XLR emblem/nameplate, install to the following dimensions:
*
Dimension (a) is 108 mm (4.25 in) from the trailing edge of the fender to the edge of the emblem/nameplate.
*
Dimension (b) is 305 mm (12 in) from the bottom edge of the fender to the emblem/nameplate.
5. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070 , if necessary.
6. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
Important: Do not touch the adhesive backing on the emblem/nameplate.
7. Remove the protective liner from the back of the emblem/nameplate.
8. Position the emblem/nameplate to the location marks and press the emblem/nameplate to the mounting surface.
9. Apply equal pressure along the emblem/nameplate to uniformly bond the item to the mounting surface.
10. Remove the protective tape from the mounting surface.