Corvette V8-6.2L (2008)
Evaporative Emissions Hose: Service and Repair
Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine (Chassis)
Evaporative Emission Hoses/Pipes Replacement - Engine (Chassis)
Removal Procedure
1. Disconnect the engine purge pipe (1) from the chassis purge pipe (2).
2. Cap the engine purge pipe in order to prevent possible contamination.
3. Disconnect the chassis fuel and evaporative emission (EVAP) pipe retainer (1) from the upper front of dash mounting stud (3).
4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Service Intervals) .
5. Remove the exhaust intermediate pipe. Refer to Intermediate Pipe Replacement (See: Engine, Cooling and Exhaust/Exhaust System/Exhaust
Pipe/Service and Repair) .
6. Remove the floor panel tunnel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement (See: Body and Frame/Exterior
Moulding / Trim/Underbody Cover/Service and Repair) .