Corvette V8-7.0L (2007)
11. Compress and align the fuel pump module into the fuel tank, while taking care not to damage the float arm.
12. Install the fuel pump module lock ring.
13. Using the J39765-A , fully lock the fuel pump module lock ring in place.
14. Connect the fuel supply line into the weld clip on the side of the fuel tank.
15. Using a DMM, verify the full and empty readings resistance reading of the fuel pump module. Turn the fuel tank upside down to achieve the full
tank reading.
*
Empty tank reading 40 ohms resistance
*
Full tank reading 250 ohms resistance
Important: Pull the jet line insert connector to ensure that the insert is properly attached.
16. Connect the jet line insert connector into the crossover tube to fuel tank opening.
17. Connect the fuel pump jumper harness to the fuel pump module (1).
18. Install the left fuel tank.
19. Connect the negative battery cable.
