S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
7. Install the other spacer ring in the groove at the end of the axle shaft. Make sure the rings are fully seated.
8. Pack the seal and housing with the grease supplied in the kit. The amount of grease supplied ire this kit has been pre-measured for this application.
Place the large retaining clamp on the seal. Now place the housing and bushing over the spider assembly. Install the seal onto the tripot bushing.
9. Check the inboard stroke position.
10. Secure the large retaining clamp and the seal to the housing with tool J 35566.
11. Remove the convolute retainer (tool 7848076) from the seal.
