Tracker 4WD L4-1.6L VIN 6 (1998)
5. Install the piston stopper washer and bolt (12) with the pistons pushed all the way in.
^
Tighten the piston stopper bolt to 10 Nm (89 inch lbs.).
6. Coat the new reservoir grommets with clean brake fluid.
7. Install the reservoir grommets (3) to the master cylinder (4). Make sure the grommets seat properly.
8. Install the reservoir (2) to the master cylinder (3). Secure the reservoir by driving the reservoir pin in using a drift.
9. Install the master cylinder assembly to the vehicle.
