Replacing Front Wheel Speed Sensor on Tracker 4WD (1998) - Service and Repair
1. Install the rear wheel speed sensor into the differential housing (3).
2. Install the rear wheel speed sensor retaining bolt.
^
Tighten the bolt to 23 Nm (17 ft. lbs.).
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
3. Connect the rear wheel speed sensor electrical connector (2).
4. Install the rear wheel speed sensor cover (1) and retaining bolts to the differential carrier (3).
^
Tighten the cover bolts to 15 Nm (11 ft. lbs.).
5. Lower the vehicle.
6. Connect the Negative battery cable.
CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live"
exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or
components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.
7. Perform the Diagnostic System Check
