Tracker 4WD L4-1.6L VIN 6 (1998)
Description
32. Separate the two ends of the driver deployment harness wires.
CAUTION: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed. Failure to follow
the procedures in the order listed may result in personal injury.
NOTICE: The rapid gas expansion involved with deploying an air bag is very loud. Notify all people in the immediate area that you intend to deploy
the inflator module.
33. Connect the SIR deployment harness wires to the power source. This will immediately deploy the inflatable restraint steering wheel module.
34. Disconnect the deployment harness wires from the power source.
35. Separate the two ends of the passenger deployment harness wires.
36. Connect the passenger deployment harness wires to a power source. This will immediately deploy the inflatable restraint IP module.
After the inflator module has deployed, the surface of the air bag may contain a powdery residue. this powder consists primarily of cornstarch (used to
lubricate the bag as it inflates), and by-products of the chemical reaction. The deployment reaction produces sodium hydroxide dust (similar to lye soap).
The sodium hydroxide quickly reacts with the atmospheric moisture. This atmospheric moisture converts the sodium hydroxide into sodium carbonate
and sodium bicarbonate (baking soda). Therefore, you will probably find no sodium hydroxide present after the deployment. Gloves and safety glasses
are recommended, however, as a precaution. Gloves and safety glasses help to prevent possible irritation of the skin or eyes.
CAUTION: Immediately following the deployment of an air bag, the metal surfaces of the inflator module are very hot. Do not place the
deployed inflator module near any flammable objects. Wait for about ten minutes before touching any metal surface of the inflator module
Disregarding these precautions may cause fire or personal injury.
37. The metal canister and the area surrounding the inflator module are very hot. Do not touch the metal areas of the inflator module for about ten
minutes after deployment. If you must move the deployed inflator module, use caution. Always wear gloves and handle the inflator module by the
air bag or by the vinyl trim.
38. Disconnect the deployment harness wires from the power source.
39. Short the driver deployment harness wires by twisting together one end from each of the wires. Repeat this procedure for the passenger
deployment harness.
40. Carefully remove the drop cloth from the vehicle.
41. Disconnect the driver deployment harness. Disconnect the passenger deployment harness from the vehicle.
