Tracker 4WD L4-1.6L VIN 6 (1998)
Tighten the wheel speed sensor retaining bolt to 10 Nm (89 inch lbs.).
12. On ABS equipped vehicles, install the electrical connector to the wheel speed sensor.
13. Install the brake rotor to the wheel hub.
14. Install the brake caliper to the rotor and the steering knuckle. Secure the brake caliper with two caliper carrier bolts.
Tighten the brake caliper carrier bolts to 88 Nm (65 ft. lbs.).
15. On two-wheel drive models, install the hub end cap.
16. On four-wheel drive models, install the locking hub. Refer to Locking Hub Replacement (Automatic Locking Hub).
17. Install the tire and wheel assembly.
18. Lower the vehicle.
